The XT-FEMTO-SPE-SXL is a very small embedded network module which can be easily integrated into any terminal. The XT-FEMTO-SPE-SXL embedded network module with the dimensions 27 x 27 x 3mm, can be built-in as SMD or as THT component and be used in your switching directly or optionally. A total of two bus systems with five switchable interfaces such as RS232, RS485, I2C, SPI as well as TTL-IO will be made available. With only a few additional components, such as a 3-pin connector and a 3.3Volt power supply, your end device is immediately network-compatible and accessible worldwide. You can bridge distances >1000m from your end device to the first switch.
Power supply:
3.3Volt / ca. 170 mA
Dimensions
27 x 37 x 3 mm
Temperature range:
-40°C .. + 85°C
1 x Single Pair Ethernet(SPE)
Signale: RX+, RX-, TX+, TX-, AVDD,
LED-ACT, LED-LINK
2 x RS232 (TTL)
Data rate : up to 2.5 MBaud
Datenbits: 7-8Bit
Parity: Odd,Even,Mark,Space,None
Signals: TXD, RXD, RTS, CTS, DSR, DTR ,DCD,RI, GND
2 x RS485 (TTL)
Data rate : up to 2.5 MBaud
Datenbits: 7-8Bit
Parity: Odd,Even,Mark,Space,None
Signals: TXD, RXD,RS485-RW
2 x I2C (TTL)
Data rate : 100KHz up to 2.5 MHz
Datenbits: 8Bit:
MasterMode
Signale: SLC,SDA
Data rate : up to 25MBit(Master)
Datenbits: 8-16Bit
Mode: Master/Slave - Mode
Signals: SCK,SS,MISO,MOSI
2 x TTL-IO (TTL)
7 Bit digital Input/Output
Security
SSLv3, TLS1.0, TLS1.1, TLS1.2, IEEE 802.1X
Supported protocols:
IPv4, TCP, UDP, FTP, TFTP, ICMP, ARP, SNMP, LPR, DHCP, BOOTP, DNS, TELNET, HTML, http, DYNDNS, SMTP, POP3, SYSLOG, IPv6, NDP, ICMPv6, DHCPv6, TCPv6, UDPv6, Netbios-NS, LLMNR, ZeroConfig(AutoIP), IP-Multicast, AK-M2M, SSL 3.0, TLS1.0, TLS1.1, TLS1.2, IEEE 802.1X
Emulations and functions:
Modem Emulation, Connect-On-Data, Auto-Connect, Tunnel-Mode ,DYNDNS-Client , FTP-Server, FTP-Client, LPR-Server, I2C - Master, SPI - Master / Slave, TTL - IO, 512 KB Flashdrive, Flash-File-System, SD- und DF-CARD, 4bit- und SPI - DISPLAY, E-Mail - Client, TCP/UDP -Client, TCP/UDP -Server, SYSLOG-Client
